Draper 230V 25A Plasma Cutter

This plasma cutter features microprocessor-controlled inverter technology making it suitable for cutting any electrically conductive material. It is a robust machine with an integrated air regulator & built-in water trap and features thermal overload protection. Supplied with an earth clamp, chipping hammer with wire brush and face mask.

Contents:
1 x Plasma torch
1 x Earth clamp (2m cable)
1 x Chipping hammer with wire brush
1 x Mask

Input voltage   230VInput supply   13A (3 pin BS approved plug)Clean cut   5mm (mild steel)Maximum severance cut   8mm (mild steel)Current output   10-25AOpen Circuit Voltage   370VDuty cycle   25% at 25AAir required   8.8cfm
Dimensions   460 x 270 x 345mm
Weight   8.9kg

Halfords takes it’s responsibility as a retailer of age restricted products seriously. We recognise that some products we sell, such as knives/blades, spray paints and solvent based products can be harmful if misused or have a damaging influence in the community.

These restrictions are required by law and Halfords does not currently permit online sales of age restricted products direct to a customers home, place of work or other address.

It is still possible to order and then collect age restricted products from any Halfords store. This allows age verification to be made in the store and is in keeping with the Halfords Challenge 25 policy.